If this works fine then any further issues are with cabling and are usually caused by one of the following issues When all your fixtures/channels are being output from freestyler start with only one actual fixture plugged in. I would also point out though that dmxking provide a configuration utility (download from here ) and once you select the virtual comport you are using the second tab allows you to select from some timing presets already created for you, and there is one there that works very well called something like 'maximum compatibility' or something like that you can send to the device that just seems to work with about anything and still keep a good 40Hz frame rate.Īlso from experience, never use a usb extension cable on a usb-dmx controller, they seem to lose frame rate or worse have communication issues that can sometimes be intermittent (but you can have a massive dmx cable coming off other end with no problems though). And I normally run 5 moving heads, 10 scanners, 12 LED parcans, a pair of miracled's, a pair of big Martin barrel effects, and other all at the same time! Normally these things are a case of following sequence it gives you carefully (such as copying file at time listed and not at end of installation sequence).Īlthough I use the dmxking ultradmx pro micro, and that has never had a problem with either freestyler, or a whole variety of lights I have used with it. The instructions, including a manual copy of files after they are uncompressed, is all in the advert you linked.
0 kommentar(er)
